Note: The following instructions apply to the Windows 95/98/Me/NT 4.0/2000 operating systems only.

1. Ensure that your 3060 or 4060 modem is connected to your computer. When you see the Found New Hardware Wizard window, click on the Cancel button.

2. On the FTP site, click the download link. When the download begins, click Save.

3. After the download is complete, browse to the directory to which the 3060_4060_Driver file was saved. Double-click on the file labeled 3060_4060_Driver.exe.

 4. The self-extracting file will bring up the following window:

 5. The setup program will come up. Read the Software License Agreement and click Accept.

 6. The setup program will now check for any existing SpeedStream drivers. Click Next.

 7. The setup program is now ready to begin the installation. Click Next.

 8. The setup program will now perform a series of installation procedures. This will take a few minutes.

9. Windows will detect new hardware and install it.

10. When the installation is complete, the congratulations screen will come up. Click Finished. You must reboot your system to complete the installation.

11. Ensure that the driver is successfully installed and that your modem is in sync by checking for the "e" symbol in your systray. If there is not a red-line going through the "e" icon, the modem is in sync and you are ready to create a PPPoE connection.

If there is a red-line going through the "e" icon, ensure that your phone line is properly connected to the modem and that there are no filters installed on the wall jack.

12. Now you are ready to browse the Internet. Open your PPPoE profile on the Desktop by double-clicking it and click on Connect.